Cable Trays
Importers in Nairobi

Cable tray nests. Ladder and perforated sections stack inside each other, so a 40 ft container holds roughly 1.5 to 1.8 km of standard 300 mm tray, less for wider or heavier-gauge profiles. That nesting keeps container utilisation high and per-metre freight low, a real cost edge over bulkier imported alternatives.

Coastal and offshore sites need hot-dip galvanizing to ASTM A123 (85 microns minimum), or stainless 316L in splash zones. For Gulf desert projects, where chlorides are low but sand abrades coatings, HDG without a top coat works well. For aggressive coastal petrochemical sites, a duplex system of HDG plus epoxy pushes corrosion life past 30 years.

Yes, where it's listed for the duty. NEC 392.60 and IEC 61537 both permit a metallic tray to act as an equipment grounding conductor, provided its cross-section meets the fault-current table and every joint keeps electrical continuity (galvanizing removed at bonding points, jumpers fitted across expansion joints). Confirm the tray is approved for EGC use before you rely on it for that path.

IEC 61537 is the global benchmark, it covers load class, deflection limits, electrical continuity and corrosion class. We manufacture to IEC 61537, IS 12352 and NEMA VE 1 simultaneously, which lets EPCs write any of the three standards into the BOQ without re-sourcing. Load-deflection test reports are available for all standard profiles, share the specification and we'll confirm the compliant profile before you commit the BOQ.