Electroforged Gratings
Importers in Nuremberg

Load class depends on expected foot traffic and any equipment or trolley loads crossing the platform; light pedestrian traffic needs far less than a mezzanine storing pallets or carrying rolling equipment. Share the intended use, span and any point loads, wheel loads or stored material weight, and we'll confirm bearing-bar size and pitch against IS 2713 or BS 4592 tables.

Yes. Panel clips, saddle or toe-board type, along with banding and fixing bolts, come matched to the panel finish so the whole system installs without you sourcing separate fasteners on site. Specify your support-beam spacing and type, I-beam, channel or angle, so the correct clip type gets included.

Standard electroforged panels run up to 1000×6000 mm, though most projects actually use smaller modular panels, say 1000×3000 mm, for easier handling and installation, then join them with couplers or banding on site. Large single panels cut down on joints but raise handling difficulty and freight footprint, so weigh that against your site's crane capacity.

Almost always, the welded grating has many small crevices that corrode rapidly without zinc coating. HDG to IS 4759 / ASTM A123 with 75–85 µm zinc is the working standard. Self-colour (un-coated) panels are used only for indoor, short-life, painted-over applications.