Cable Trays
Importers in Ibadan

Cable tray nests. Ladder and perforated sections stack inside each other, so a 40 ft container holds roughly 1.5 to 1.8 km of standard 300 mm tray, less for wider or heavier-gauge profiles. That nesting keeps container utilisation high and per-metre freight low, a real cost edge over bulkier imported alternatives.

Coastal and offshore sites need hot-dip galvanizing to ASTM A123 (85 microns minimum), or stainless 316L in splash zones. For Gulf desert projects, where chlorides are low but sand abrades coatings, HDG without a top coat works well. For aggressive coastal petrochemical sites, a duplex system of HDG plus epoxy pushes corrosion life past 30 years.

Yes, where it's listed for the duty. NEC 392.60 and IEC 61537 both permit a metallic tray to act as an equipment grounding conductor, provided its cross-section meets the fault-current table and every joint keeps electrical continuity (galvanizing removed at bonding points, jumpers fitted across expansion joints). Confirm the tray is approved for EGC use before you rely on it for that path.

Commercial real estate, Grade A offices, hospitals and retail malls, is the largest single market: HDG or pre-galvanized trunking in 75×50 to 150×75 mm for power, data and fire routes in partition walls and raised floor voids. Pharmaceutical plants (Hyderabad, Pune, Ahmedabad) specify stainless 304 trunking for cleanroom and production-area runs, with screw-fixed covers and welded continuous joints. Telecom data centres in Mumbai, Hyderabad and Chennai use 200×100 mm HDG trunking for horizontal cable management between cabinets. Metro rail projects specify fire-rated HDG trunking with IEC 61537 fire integrity evidence for signal and communication runs. We stock all four profiles and can consolidate mixed-product deliveries on a single bill of lading.